![device usb vid requires further installation device usb vid requires further installation](https://www.minitool.com/images/uploads/news/2020/01/device-requires-further-installation/device-requires-further-installation-2.png)
- #Device usb vid requires further installation install
- #Device usb vid requires further installation drivers
- #Device usb vid requires further installation software
If the device is not listed in the Device Manager look for devices that have an "!" marked next to them, that have a name such as "unknown device", "other device" or devices you know you do not own, i.e. NOTE: You can also get to Device Manager by right clicking on My Computer, then clicking on the Hardware tab and then the Device Manager button. If it is, move on to Step C, otherwise continue with Step below. In your case, the Pinnacle device you installed must be listed similarly but with it's device name. The DVC 100 is listed below as an example. If the device is listed properly under the Sound video and game controller section, it will look like the picture below.Click on the "+" symbol (plus sign) to the left of the heading Sound, Video and Game Controllers.
#Device usb vid requires further installation drivers
Once Windows has found drivers for the device, check in Device Manager to see if the driver has been loaded properly using the following steps: Typically, C:Programfiles\Pinnacle/Studio14. Browse to the location on the hard drive you installed Studio to, which is typically your C: drive. If it does not, the Add New Hardware Wizard may ask you to browse to their location.
![device usb vid requires further installation device usb vid requires further installation](https://cdn.windowsreport.com/wp-content/uploads/2020/04/Device-requires-further-installation-in-Windows-10-S1-P3-1.png)
(NOTE: Some of our devices only work with USB 2.0 ports and you need to connect these devices to a USB 2.0 port, not a USB 1 port) Windows should find and load the drivers. Now that you have Studio installed, connect the USB device up to the proper type of USB port on the system.
#Device usb vid requires further installation install
Please disconnect any Pinnacle USB capture device before you install Studio. If Studio is not installed, please do so now. Have you installed Studio 14/15? All the drivers for the supported hardware install automatically when you install the Studio software. To begin, check to see if the device is loaded and detected by Windows by following these steps. (Note: Some devices like the MovieBox, uses the same hardware as older packages and may show in the device manager with another name like 710 USB) Your hardware will be displayed with its hardware name. In the images below, the Dazzle DVC 100 is used as an example of how the device is displayed in Windows and in Studio. Most of these devices install in the same way, any differences will be noted.
#Device usb vid requires further installation software
It will cover the software and hardware installation of the: This troubleshooting guide will help you troubleshoot all Pinnacle USB capture hardware installations that are compatible with Studio. This document will assist in installing the hardware and selecting the Pinnacle device in Studio. If you have and it still does not work, follow the steps below. Please confirm, you have checked those setting in Studio.
![device usb vid requires further installation device usb vid requires further installation](https://abigail909smithhome.files.wordpress.com/2020/04/mcafee_blog-1.jpg)
Studio does not have the correct port selected, either Composite or S-Video.Studio does not have the Pinnacle device selected as the Capture Source.In most cases when a USB Capture device does not work with Studio it is due to one of the following reasons: